Recent content by Ford15

Looking for a 4.88 gear set for a rear dana 80.

I'm looking for some info on the v2.75 cam in a p pump. Just wanting to know if any one has mm's to lift conversion numbers??? I don't think a 215 cam chart numbers work or at least my dial indicator isn't matching numbers.

Dodge body 12v 5x25 dual feed injectors used 155* spray 50-60 hooks. Bought new from Schied. $800 US. Ship to Canada and USA

Dodge body 12v 5x25 dual feed injectors used 155* spray 50-60 hooks. Bought new from Schied. $800 US. Ship to Canada and USA

Looking for a tail housing off a NV4500, must be a 2wd Dodge. And willing to ship.

Wanting to buy a good intake runner and lines for a 12v. Let me know what's around.

Before I call Hart's where is the best place to get the bell connector with orings that takes the bolt on slide plates for the compressor housing?

Looking at filling my block with a Loctite backing compound epoxy. Has anyone else tried this stuff? I think the name is Loctite PC 9020.

WTB a waterman fuel pump/setup for a 12v. Just checking to see what's out there before I make the plunge.

12v roller rockers, stock ratio or close to, have a little clearance to work with. Message me at 9023011257.

Looking for a big single s400 frame preferably a 1.32 a/r 96mm 88mm turbine housing. Maybe a s488?? :st:

What are some of the lowest air pressures you have run your tires at? Also what increments are you changing the pressure at?

Not much luck with 35 spline any 37 spline dana 80 srw axle stuff laying around?

Anyone have some upgraded 35 spline axles for a drw c&c dana 80 they might want to part with?

Looking for a turbo for my puller because Jeb may not have my cover done in time. I'm running a billet s480 so lm looking for some thing similar. What do you got?