Recent content by gwhammy

I'm getting old and forgetful, think I've read the electric shift transfer case won't go into low lock if when I put the 47rh in front of it. Is this right?

I drove my fummins this morning pulling a trailer to a job close. Had to take it home to get dump truck for one load got back in it to go back to the job and when I started it it went wide open. I shut it off immediately and set for a few seconds then restarted it. It didn't go wide open this...

I'm working on a 2010 super duty putting a ve 12 valve in it. In my 09 I used the 5r110 but I'm really looking at putting a 47rh in this one. It's basically going to be a driver and after fighting the other one I'd like to have simple on this one. Anyone done this.

Is anyone using one of these and how good does it work? I'm looking for any way to keep a 5r110 and what I'm doing just isn't working very good. If not it's probably going to be a 47rh, I know what I'm getting with them.

My 09 f350 with the 12 valve cummins just started having trouble with the tach. It will run a few minutes fine and then start having a bouncy tach and battery light coming on. Last time I drove it today the tach quit completely coming home but works when starting it in the garage. It did the...

Probably isn't worth much but I have the turbo, intercooler and all the piping off a 93 cummins. I really don't know if it has a value other than scrap but someone might be hunting for this stuff. Truck was stock with 290,000 miles, never did anything but get driven.

What size are the tips? From what I'm gathering they are the same as later 12 valve in diameter. Is this right? Going to the put bigger injectors in a motor I'm swapping while I have it out.

I just bought my first ve pump motor today, a 93 with 289,000 miles. It's totally stock and and never done anything but be driven. I'm putting it in a 2010 f250 sometime this summer. How long are these pumps good for before needing rebuilt? I'd like to push it with the normal bolt ons and some...

Looking for a complete running or rebuildable 12 valve. Thanks

How much boost are these good to?

My 02 dodge has a voltage draw with the key off. It's had it on and off for a couple years but seems to have gotten worse. It will completely drain the batteries overnight. You can take the ground cables off and see a spark when you touch one back to battery. I unhooked the ground cables and...

I bought this from a guy that had it built and ran it a little while and then went bigger. I put maybe 1500 miles on it but to big for my use. Basically new. 600 plus ship

I put one of these on the fummins I just got running, just a little bit to slow spool for trailer towing. Has anyone done the 62 mm he351 with the 67 exhaust wheel and how does it spool compared to a stock he351.

I'm needing a replacement wheel for the front of my 09 f350 with aluminum wheels. They have the eight round holes but are larger than all the ones I see advertised. The holes go onto the flat part of the face and almost to the flat part of the rim. I can't find a name and don't have caps for...

Who is out there that will cut a used convertor to rebuild them or just check them out? I have a couple that have been in broke transmissions I'd rather check than just put them in.