Recent content by nrussell

'06 Turbo to intercooler pipe with stock boots no clamps-$25 '06 48RE stock transmission cooling line-$10 '06 48RE tranny dipstick tube only-$10 '06 Drivers side pillar with handle, grey interior-$15 '06 stock intercooler tubing(both pieces,no boots)-$20 '07 5.9 CR motor wiring harness, good...

4 Brand New Kuhmo Venture M/T's for sale. 265/70/17 Load E 10 Ply Asking $700 for set. They can be picked up or shipped from my home town of Villa Rica, Ga.

I have a Helix 2 cam for sale-$475 + shipping

I will be dropping motor in truck tomorrow morning, how should I break in the motor? Thanks

Does the Silver62 have a t3 or t4 exhaust? Does the S400 have a t4 or t6 exhaust? Thanks

I pulled my Helix2 out today because I'm swapping it into my new rebuild and it looks like hell. Only the lobes not the journals. The sad part is it only had about 8k miles on it. What do you guys think went wrong?

-exhaust manifold -turbo -ecm -cam -cp3 truck had 89k miles -s06 smarty -tstr49 make best offer

Looking to rent a Cummin's engine stand, is this even possible?

I want to send '06 head out to be reworked. Who do you recommend? And what should I have done to it? I'm in Georgia, anyone close? Thanks

Here in the past week I have noticed a lub..lub..lub..lub..lub noise you can hear in air intake and exhaust pipe. I have changed air filter and all 3 fuel filters and adjusted valve lash, and its still there. It seems to be more sluggish and heavier smoke down low until boost gets to about 10psi...

I'm no wiring genious. Would someone school me on how to wire an on/off switch to my fass pump? Thanks

I am asking $500 for this pump

I am asking $250 for this pump.

I downloaded new Revo software :badidea:and cant go back to older software. I cant even use regular TNT either. And Bob just gave me TNT/R today too:banghead::banghead: I'm bummin'!!!!!!!!!!!!! Thanks in advance. Neil

I have been running Revo TNT(regular not R) basically since it came out. I thought I blew a head gasket.............again! So I unloaded the Revo-TNT(regular not R) and then loaded just Revo and had same popping going on. So I just put ecm back to stock and went out and flogged the crap out of...