Recent content by straight 6 roar

Thinking about buying a dual cp3 kit during Black Friday since I already have an LBZ pump and I’ve heard duals have better pedal response. 1.) The ATS kit is dual feed to the rail, has anyone encountered restrictions with the single feeds? BD, Fleece, PPE, Industrial, and H&S appear to be...

Looking for 75-100% over injectors (150-200 hp) for 04.5-07 Cummins. Exergy or S&S preferred but may consider others if the price is right.

Looking for a good 98-02 exhaust manifold. No cracks, shrinking, warping etc.

I need a straight discharge cover for a 62mm S300. Also need a short wastegate actuator for a 12/14cm S300 turbine housing. I believe the 3rd gens use these a lot. Thanks!

Pretty rare little guy. Got a T3 .80 non-gated housing for 71mm turbine here. Has the standard S300 4 bolt mounting tab arrangement to the center section and then a HX40 outlet. Spooled very fast, 150-200 rpm faster than my current .80 gated. There are 2 cracks in the divider, however since it's...

Looking for a Borg Warner s300 62mm compressor cover with the 2nd gen vband outlet. PM me would be best

Never ended up using it. Guy before me sawed the wastegate flange off it kinda haphazardly, will need a flange for your specific gate welded to it. $60 shipped 116.jpg Photo by bermbanger | Photobucket

Almost new just been wrapped up sitting around in a box for several months. About 3000 miles on each. 5x.014's are VCO from SDX and the 7x.012's are sac from contagious diesel. Verified both sizes with pin gauges. 5x.014 - $475 obo shipped no cores needed 7x.012 - $475 obo shipped no cores needed

Steering shaft U-joint completely came off the box splines this weekend and had zero steering control around a corner. By the grace of God I was going 20 mph, around a gentle turn, uphill, on an empty road. The night before I had 3 other guys in the truck going 75 on the interstate for 100...

Looking for a 65mm turbine out of the s300 frame turbos. This might also come in bigger s200's as well. Let me know what you've got.

I'm doing a project in my advanced CAD class and decided to do a piston. However, I haven't picked one yet and I'm going to have trouble modeling one unless I can get some sketches from y'all. I'm going to model it in Solidworks and then do stress & heat analysis with ANSYS at school. $$$$$...

Just got accepted into OCS for Summer 2011. Feels fantastic, can't wait to give it a whack. Any words of wisdom from you guys that have been through it?