Recent content by zsk7687

Been away from diesel trucks for a while, and I'm not very familiar with the vp44, always had a 12v. Picked up a bone stock 99 2wd auto 3500 with 376k miles. Bought it just to haul hay and pull a cattle trailer. The truck had sat for about a year and a half before I bought it, but it fired right...

HX35 off of a 97. No leaks, minimal side to side shaft play, no in-out. 12cm exhaust housing. $200 plus the ride BNIB HT3B. 74/96, 26cm housing. Opened up for pictures and to check shaft play. $400 plus the ride. Paypal only. Will post pictures when I get to a computer.

What is the recommended oil orifice size for the oil inlet, or is it already in the inlet to regulate oil pressure. Thanks in advance.

like the title says I need a stock 12v exhaust manifold. thanks

NIB HT3B. 26cm housing. Hasn't seen a truck at all. Box was opened just to make sure all was well, and to check shaft play. Pics are available. Asking $500 + shipping. Talk to me.

Here's the craigslist ad.

Just installed a set of Weston's 7mm DV's, and after install my idle dropped considerably. Raised the idle back to ~900 in park, but it drops well below 500 when put in gear and stalls. I've searched around and figure my gsk will be my next adjustment, but have seen some say tighten and others...

Got a NIP Suncoast Extreme Rebuild kit I bought from CCP a few weeks ago. Going a different route with my transmission. I'd like $500 shipped. Also got a Transgo TFOD Diesel shift kit that needs to go. I'd like $100.

Mocksville, NC

Info's on the craigslist ad's. Pics were too large, so PM or email me for pictures. Gibson SG Special 2000 Fender American Stratocaster

noticed some steam coming from the blowby tube so i figured i'd check the oil fill tube. when i pulled the cap off the steam was real obvious even with the wind from the fan. i also heard a constant squeak/squeal when i had the cap off but it was gone when i put it back on. my serpentine belt is...

ive been reading over threads and writeups but am still a little confused. the banjo on the pump needs to be tapped then a hose rune from it to my isolator, then isolator to gauge. is a needle valve still necessary with a mechanical gauge and if so will it need to be before or after the...