Search results

I have a NV4500 that came in and I'm rebuilding. Needs a handfull of stuff. My question; Is anyone familiar w/ Kennys Pulling Parts out of Kentucky? (Truck parts, tractor pulling, clutch assembly. Waynesburg, KY) He is telling me he has one of their tripple disk set-ups, not sure which one...

Wondering if any of the fellow forum members are running the Recon tripple disk torques? We've sold a couple through our supplier, mostly to guys who DD drive their truck w/ a programmer/chip, nothing getting too serious. They have 3 multi disk torques 1000ft/lb 1100ft/lb and 1200ft/lb, the...

Have a OD unit from a 47RH 4X4 forsale. This was out of my buddys '95 we yanked the tranny when he burnt the direct clutches up and went through the entire thing, replaced what was needed. The steels/frictions and seals are all good and operable in this unit, also includes appropriate...

Well here is the story. On Saturday I hit some jersey barriers getting off a local highway and it bent the hell out of my right outer tie-rod end. Nothing was affected besides alignment obviously. Then on a tuesday I had to go 4x4n a little bit to get a buddy unstuck out of a mudhole...

Well I've been dealing with a miss/stumble that I have yet to find since I drag raced back in May. When the miss first appeared I lost all oil pressure (made my heart stop). So I went and installed a manual oil pressure gauge. So I got oil pressure out the waazooo.. This is how the truck...

I have a brand new ZF 5 speed output shaft for 4x4 that I am gauging interest in. If Interested PM ME!

I'm gauging interest in a brand new NP435 4 speed out put shaft for 4x4 IF interested please PM ME!

I'm wondering how much fuel have people pushed out of their 160HP pumps reliably? What amount of fuel is needed to reach #600-675HP/1000+ TQ? And can the #160 pump be sufficient up to those numbers? What am I looking at price wise to get this pump push 300-400CCs of fuel, what needs to be...

I recently got my head resurfaced, o-ringed, #60 valve springs and ARP 12MMs. I plan on running a SPS62/12 turbo (or equivalent). I recently got my injectors pop tested when the head was getting worked and they failed. I have read on numerous sites about the spray pattern on the 370s. So...

Hello everyone.. Just wanting to introduce myself; My name is Jared, I'm 18 years old. I'm from Somerset, Pa. I have a 1995 Dodge Ram 3500 Cummins. 370 injectors, 191 DVs, 0 plate slid forward, free washer GSK kit, K&N CAI, NV4500, Luk Cermatalic.. I just got the head resurface o-ringed, 12MM...