Search results

My 2012 3500 has a abs and brake light on the dash. I ran sanner on it says rear abs sensor. I changed it still have the lights on and scanner still says bad sensor tried clearing codes no luck. The cruise don’t work and the speed don’t work when i raise the rear tires ive did a continuity test...

2012 136,000 miles raceme ultra s&b intake deleted 4" exhaust gutted crank case filter Exhaust brake surges and sometimes it don't work at all it kicks on and off when truck is cold and surges when accelerating the exhaust pressure gauge on raceme is pegged I cleaned the sensor tube and put new...

2012 3500 6spd 133,000 mile the exhaust brake doesn't work most of the time but it kicks in every time on cold mornings I cleaned back pressure sensor and tube and nothing changed

I just picked up 2012 deleted with h&s mini max I also have race me ultra which one would be the best

Clean 2007 dodge 3500 dually 4 door 6.7 cummins 4x4 6spd manual all deletes are done h&s tuner 5" exhaust leveling kit bfg allterrain 85% bradford built skirted flatbed truck has been in ILLINOIS for three years no rust 231,000 miles $24,000 obo clean title in hand 8159933087

I got a 07.5 3500 4x4 crew cab dually manual I got a vibration 65-75mph I've had new drive shaft made put new tires on and balanced took front drive off and a alinement done put a couple tie rods and track bar even when to 22.5s and can't get rid of the vibration any ideas

Looking for 2nd gen silver bullet turbo 62mm

07.5 6spd 3500 with h&s mini max 5" exhaust and cold air intake all deletes done the exhaust brake just started sticking on after slowing down and then get my on the throttle and the brake stays on and a lot of black smoke pull it out of gear and then it's fine any ideas what's wrong

Have nice smarty s-67 fits 07-12 6.7 don't need anymore went different route $550 plus ride send me your email or phone number I can send pics

Going through my 07.5 after buying it i had to put rear brakes on and two new calipers bleed brakes the old fashion way many of time and pedal is still spongy do I have to bleed the abs some where I'm new to a vehicle this new

Just got 07.5 it all the deletes done and computer has been reflashed I'm getting see dealer service required and codes are 423,616,50

I need a 241dhd slip yoke

Need a nv4500 2wd slip yoke 31 spline and a pto

Looking for a good hx35 turbo

Looking for nv4500 pto for a project

Looking for plunger and barrels for my 4bt build Bosch part number I'm looking for are 2418455007 they are 13mm

I got 04 2500 4x4 6spd Im getting about 14-16 mpg I have edge juice Cs open exhaust and a cold air intake no matter what setting I have the edge on

1996 Dodge ram 2500 odometer: 199000 paint color : white type : pickup drive : 4wd fuel : diesel transmission : manual title status : clean cylinders : 6 cylinders Clean southern smoke free 96 dodge ram 2500 4x4 5spd p7100 12v cummins diesel excab long bed truck has bfg all terrain 33s, 7" miter...

I just put a fuel pressure gauge on my 04 for lift pump pressure and I'm not getting any pressure I can hear the pump running and getting fuel out of lines with key on is there a relief valve that goes bad

On my quad cab 04 the drivers rear window will not go up or down I put in a new master switch it didn't work right I pulled the window motor a part it works both ways swapped the door switch with pass one still don't work ground out one of the wires to the motor and then it would roll down on...