Search results

I have a 1999 truck that i got with a bad 2000 engine in the back. I rebuilt the engine and trans and installed them into the truck. The ECM, wiring harness, and engine are all from the 2000, and match with each other. The problem I am having is the engine will not fire. After bleeding the...

I am hoping someone can give me some measurements from their throttle linkage components. I have a 2001 with a manual and i want to do the APPS mount on the pump. I made a mounting bracket mimicking the Crazy Carl setup. I just need the measurements for how much to extend the bell crank on the...

Last July I installed a new VP, new overflow valve, ISSPRO mechanical fuel pressure gauge with a snubber, aftermarket filter mount with a Cat 1R-0749 fuel filter, sump kit and a Raptor 150. I have maybe 20-30 hours on this system. Had several problems in the beginning, but they more or less...

Well, my head studs just arrived, so here in the near future I'll be pulling my head to put in a new gasket, touch up valves, o-ring, etc. After I get the studs in and get everything leveled out, I want to get my compounds set up. I will be running an hx-35 and a BHT3B. With a stock VP44 and...

Well, my head studs just arrived, so here in the near future I'll be pulling my head to put in a new gasket, touch up valves, o-ring, etc. After I get the studs in and get everything leveled out, I want to get my compounds set up. I will be running an hx-35 and a BHT3B. With a stock VP44 and...

I have engine mounts from an 2000 ex plow truck that I want to repair to use on a truck. My plan is to use a milling machine to bore the bolt hole out to 5\8" and then sleeve it with some 1\2" ID chromoly tubing. My only other option would be to buy new ones, but I really don't want to spend the...

So, I acquired a used Diablo Sport PowerPuck (2 plug, MAP sensor/CanBUS type), then after realizing it was for an 02, I bought an 01-02 MAP sensor adapter. Plugged it in this morning, fired the truck up, no oil pressure gauge, and CEL was on. Scanned the codes, Turbo Boost code, and Grid Heater...

I inherited a project, '99 engine swapped into '00 truck, that wouldn't start. I got the truck running, crank sensor unplugged and fuel pump electronics all haywire. Truck runs great, starts fine, etc. However there is one hiccup I can't figure out. After the grid heater cycles check gages...

I have a complete '99 that the engine has been removed and successfully swapped into an '00 (manufacture date 05/00), leaving me with the '00 engine and tranny in its bed. Now I want to swap the complete power train from an '01 manual(maybe 01.5, has rear discs, limited slip rear end) into the...

I know I'm kind of beating a long dead horse and I'm years behind, but I read thru every post on this forum that might have the answers to my questions, but couldn't find them. I've been reading for 2 days during any spare minute. 2001 near stock with manual transmission. Approx. 500k miles. I...