47re to NV5600 swap

acampb12

Pig guy
Joined
Jan 27, 2007
Messages
119
I'm getting ready to do this conversion here in a week or two and I'm trying to compile my list of what I need and want to make sure I don't miss anything and have to make last minute trip(s) to town.

So far what I can think of:
Clutch master cylinder
Slave cylinder
Pedal assembly
Drive Shafts lengthened/shortened (which I'm not sure if the front needs to be shorter or not)
Fluid
Clutch/flywheel
Starter spacer


My source for the tranny also has a t-case and shifter so that is taken care of. I'm sure I'm missing something and if someone else has done this any pointers would be appreciated. Also does the NV5600 have a different bell housing bolt pattern or will it bolt right up???


Adam
 
I believe the front DS will need to be lengthened and the rear shortened. Post some pics when you're done. I've thought about doing this swap on mine. Best of luck to ya.
 
alright whats the best way to go about adding length to the vac lines that run to the t-case??
 
Back
Top