rightwinger
New member
- Joined
- Jan 11, 2013
- Messages
- 101
What is the largest sleeve I can have installed in a 24V block? I have searched this a good bit and people are saying that you can only bore a block
.040 over, but I'm not finding much information on sleeving a block. I'm planning on using a 6.7 crank in this block, and trying to squeeze enough cubes out of this block to get me to a 6.4L. I've read all kinds of stories or threads where people mention getting 400+ cubic inches out of a 5.9 block, but I have yet to specifically hear how they went about doing it. I've seen a lot of people speculate about how they think a person achieved this, but I would like to hear from someone who actually has sleeved a block to a substantially larger size than the .040 over. Any information would be appreciated.
.040 over, but I'm not finding much information on sleeving a block. I'm planning on using a 6.7 crank in this block, and trying to squeeze enough cubes out of this block to get me to a 6.4L. I've read all kinds of stories or threads where people mention getting 400+ cubic inches out of a 5.9 block, but I have yet to specifically hear how they went about doing it. I've seen a lot of people speculate about how they think a person achieved this, but I would like to hear from someone who actually has sleeved a block to a substantially larger size than the .040 over. Any information would be appreciated.