Drive shaft loops

[f6jbob]

Whose still making the round tube style drive shaft loops? I tried pm'ing the guy from Oklahoma Toolman something but never got a reply. Anybody know of another source?

 

[displacedtexan]

IIRC Hellman does...

Aaron isn't really on here any more, not sure if he sees him PMs, I'll text him to check.

 

[f6jbob]

Thanks Nick

Jim

 

[displacedtexan]

No problem, I figure as much crap as I post, being useful occasionally isn't a bad idea!LOL

 

[joefarmer]

What truck do you need them for? I may know a guy that can make you a set.

 

[f6jbob]

Brandon

Its a 94 rcsb. Dodge of course!!

Jim

 

[paulb]

I use Joe Hellmans on both my trucks.

Paul

 

[f6jbob]

Brandon

Its a 94 rcsb. Dodge of course!!

Jim

I should add that its a 2wd.

 

[ENafziger]

Mike makes them.

Kool Parts

--Eric

 

[Hurley]

Mike makes them.

Kool Parts

--Eric

I like their stuff.....but this is a complete turn-off for $95.00 (i know, I know, added value):

 

[BlakeW]

Is another loop needed behind the carrier bearing? Rulebook only says 6" behind the trans.

 

[joefarmer]

I think the intention is to keep the truck from pogo-ing on the driveshaft. I would imagine one within 6" behind each u-joint would be correct.

 

[otto_121212]

is there anything in the rules about u joint shields? we have to run those pulling in Montana now...

 

[toolmanoffroad]

IIRC Hellman does...

Aaron isn't really on here any more, not sure if he sees him PMs, I'll text him to check.

Im back to being on every night... Dam CompD is a hell of a drug... :hehe:

 

[Sancrest]

Just make your own. I took a piece of 6' pipe cut just a little over in half. Weld to a table and lay a piece of flat bar in there use a porta power and bend away. I made 2 halves then bolted together.


Sent from my iPad using Tapatalk

 

[jkidd_39]

Mike makes them.

Kool Parts

--Eric

Jesus! Those pieces are nice and they are proud of them!