Garrett charger oil feed???

Willy91

New member
Joined
Jan 12, 2007
Messages
1,520
Hello I have a Garrett T18A that I am going to be running as the primary in my compound setup, and looking for the oil feed for it. I found some feeds that fit Garrett T3, T4, T04E, T60, T61 / T67 25G Turbos, that look close to what I need. wondering if they are the same as my T18A. Thanks
 
Hello I have a Garrett T18A that I am going to be running as the primary in my compound setup, and looking for the oil feed for it. I found some feeds that fit Garrett T3, T4, T04E, T60, T61 / T67 25G Turbos, that look close to what I need. wondering if they are the same as my T18A. Thanks

anyone?
 
I'm assuming yes, but if you look on the garrett website, there is a dealer in Houston, TX that's been helpful in answering questions for me.
 
Ok so I figured out my oil lines finally, now the new problem. I had a 5" v-band flange off of a c-15 cat I was going to use for my exhaust but it's to big, by a little bit. Anyone know what exhaust flange these take? Thanks.
 
On the Garrett site you can get all the info you need about your turbo.
 

BJ,

If you click the link and scroll down, you will see a 5" and 6" exhaust outlet for the T18A, and right below that they have a (2) 6" v-bands for the outlet. I am sure they have a 5" v-band for the 5" outlet (if that is what your turbo has) if you call them, although it does not appear to be listed on their website. They are also close, and shipping would most likely be next day or second day ground.

Kyle
 
BJ,

If you click the link and scroll down, you will see a 5" and 6" exhaust outlet for the T18A, and right below that they have a (2) 6" v-bands for the outlet. I am sure they have a 5" v-band for the 5" outlet (if that is what your turbo has) if you call them, although it does not appear to be listed on their website. They are also close, and shipping would most likely be next day or second day ground.

Kyle

ok yeah I'll give them a call, thanks Kyle
 
Back
Top