The Highwayman
New member
- Joined
- Aug 12, 2011
- Messages
- 3
So, I have an LB7 and increased the diameter of the Y-bridge inlet to 3". Then I figure out that the Fuel Pressure Relief Valve and banjo fitting (out of the distribution block) hit my intake. I need to find a 45 degree fitting to adapt the Fuel Pressure Relief valve out of the way. Has anyone run across a fitting like this? It would have to be 16 mm 1.5 male on one end and 16 mm 1.5 female on the other. I could use a 45 or 90. Any help is greatly appreciated!