Yesterday I replaced all the u-joints in the rear drive shaft because one was cracked. When slipping it back in I noticed my transfercase output seal is dry rotted and cracked all the way though almost all the way around. So my question is what is everyone using to reinstall seals??
I have always wanted to get a all around kit for doing them. Sick of using the hammer trick to tap them in evenly. On top of all that it seems my inner axle seals are leaking on the front and rear axles. The tubes seem to be seeping at the houseings where the tube goes into the differential housing. They have a nice build up of dirt and dust around them. So a all around tool kit would let me knock all this out.
I have always wanted to get a all around kit for doing them. Sick of using the hammer trick to tap them in evenly. On top of all that it seems my inner axle seals are leaking on the front and rear axles. The tubes seem to be seeping at the houseings where the tube goes into the differential housing. They have a nice build up of dirt and dust around them. So a all around tool kit would let me knock all this out.