roachie Taco Master Joined Nov 2, 2007 Messages 11,133 Oct 6, 2010 #1 What is the difference exactly? Using VP injectors in a CR head, I cant recall.
Diehard Ram Sled puller no more Joined Dec 30, 2009 Messages 688 Oct 6, 2010 #2 CR Cross tubes have a tapper to them. The vp cross tubes don't have a tapper.Except for at the end of the tube. Where it goes into the injector.
CR Cross tubes have a tapper to them. The vp cross tubes don't have a tapper.Except for at the end of the tube. Where it goes into the injector.
roachie Taco Master Joined Nov 2, 2007 Messages 11,133 Oct 6, 2010 #3 That's what I was thinking, was not sure if the o-ring was in the same location, ect. I have a set of 0.093's that I was thinking of tapering to fit.
That's what I was thinking, was not sure if the o-ring was in the same location, ect. I have a set of 0.093's that I was thinking of tapering to fit.
roachie Taco Master Joined Nov 2, 2007 Messages 11,133 Dec 2, 2010 #4 I'm throwing this back up for more input before my tubes end up in a late and destroyed. Anymore input?
I'm throwing this back up for more input before my tubes end up in a late and destroyed. Anymore input?
Rich Buckley Opie shaft twister Joined Feb 6, 2007 Messages 1,219 Dec 2, 2010 #5 its ez-er to use cr tubes and get vp to cr head lines or change the nuts out on the head end of the stock lines.
its ez-er to use cr tubes and get vp to cr head lines or change the nuts out on the head end of the stock lines.