The pump is new and has had NO fuel through it. Was bought for a 12v Cummins project truck but never used. Includes pump and wiring harness.
Asking $400
This pump came off of a 96' 1 ton and was sent to PDR diesel. It got a complete rebuild and barrel turn. It flows 600cc's with PDR taper cut DV's. It also has a 4K governor springs, mack plug and AFC spring kit. Currently has a #10 fuel plate.
$2200
S480 1.32ar from engineered diesel.
S364/14
Twin set exhaust connection pipe
Both have never been ran. The 364 has some surface rust on exhaust housing from being installed as a mock up in a conversion. All openings have been taped off except for pipe fitting. Comes with oil line fittings...
I haven't had any luck searching so here it goes... Ive been working on a friends truck and ran into a thermostat problem. The truck is a 94 3500. My first attempt was with an autozone t-stat and it as to big so i read on here to use a factory t-stat. The next problem is that the cummins t-stat...
i got a 2nd gen 12v ive been goin through for a friend. i took the block to the machine shop to get the bores freshened up. the machinist called me today and told me he could clean and match the bores at .005 over. my question is will that be ok to go back with stock pistons and rings or will i...
what it the bore size of the cluth master cylinder on a 2nd gen 12v. im using a wilwood pedal assembly in my truck with one of their master cylinders. i just want to make sure the bore sizes are the same.
thanks!:rockwoot::rockwoot:
i got a new 64/14 s300 and i was boltin it up. out of habbit i happened to grab both ends of the shaft a move it around. it felt to me to be a little excessive movement. there is about 3-4 thousandths end to end and about .036 moving the compressor wheel side to side. what are the tolerances...