I have a brand new VP44 here i went to the p-pump and took this to goff diesel injection in salt lake city he completely went through the whole pump everything inside is brand new and ready to rock and roll looking for 800 bucks OBO no core needed
How much line pressure in a 47re is to much line pressure i built my own tranny and would like to crank it up as much as i can without blowing seals.........
i built my own tranny it holds great but i keep throwing it into limp mode after a hard pull i have seen the delete kits around for a while just wondering if anyone has any experience with them or should i just put a resistor into the wiring harness.....................
A while back i remember seeing some one used there 24v throttle cable with there p-pump conversion but for the life of me i cant find it again i was wondering if anyone could point me in the right direction i have searched for a few hours and came up with nothing
Ive got an external wastegate here it measures 48mm dont know what brand it is but it is a very well built piece i aquired it in a trade looking for $300 but will except trades for aftermarket valve springs or gauges or possibly some 022 or 024 delivery valves for a p7100
I picked up a p7100 this weekend for my swap i was told it was a 180hp pump but im not to sure i only paid 200 bucks for it s either way im not to mad about on the upper left hand corner of the id tag it says 908 . and then the 10 digit serial number is 0 402 736 841 any help would be appreciated
I am p-pumping my truck so i am selling this to help fund the project let me know if you have any questions works great never had a single problem looking to get $550 shipped
i have searched and cant find anything helpful with these codes the truck started cutting out at full throttle
0251-injector pump fuel valve feedback circ
0252-injector pump fuel valve stuck
0253-injector pump fuel valve on circ
they are not the usual injector pump failure code just dont know...
So i attempted to build my own tranny it was going good and easy we get it shoved in the truck and it wont go forward, reverse works great but no forward you put it in drive and it rolls forward but when you hit the gas nothing it feels maybe like its trying to grab a little..... any help is...
I have found an ht4c here locally for dang near free i was just wondering if anyone has any experience with this turbo is it to big for a set of twins with say a 62 on top any help is appreciated thanks guys and could my little VP even spool it