I have a set of Flux 3.5 injectors. I sent them to Don they had 40k on them when they were upgraded. Nothing wrong with them when set out as they were gone through and checked out. Since they have come back they may have 500 miles on them at most. Used to dyno and sled pull all summer. I have...
I have a 2.8 turbo that is a 76mm bushed down to a 2.8 It is new in the box. It has everything down to the race cover. its a 76mm with a .90 a/r looking to get 1650 out of it.
I have a new in the box PPE Dual fueler kit for a 03-07 Dodge. I was going to put it on a Friends truck but we couldn"t run it with the rules up here in the 2.6 class so its for sale. 1850 shipped to your door or I could meet you at Schieds this weekend with it.
I am selling these for a buddy of mine. They are like new as they were put on and the started to dyno but noticed they had a head gasket out. So they have been ran for like no time (20 min). It is an HTT 62 over a GT42 (76mm). They are both wastegated. I have no pics as the trucks at Floor It...
Well guys its pulling season and they are not letting us pull this year with twins so here goes. I am selling a HTT 66/13 over a 94mm bottom turbo. Nate at MPI did all the piping and and wastegate setup. The 66 uses its stock gate and the 94 uses a Tial gate. The kit has dyno time and I used it...
I have a 3850 CB 12 button DD for a G56. I was going to swap it out in my tow rig but I figured out what was wrong with the one that is in there so I dont need it. I do not have hydro upgrade so the first 1250 takes it home through paypal.
Well we have found the limit of basic head studs and stock MLS gasket. When trying to get over the 1000 hp mark on first run we had a bunch of flooder not sure what it was as I thought it may have been a wastegate issue after checking and turning Smarty down a bit we started to make another pass...
I have a ported and coated 2nd gen Manifold for sell. It was on the truck for 2 days untel I got a header on. It will work well in a single or twins setups. Looking to get 350 for it.
What is the piston protrusion on an 05 Stock motor. Also how thick is the MLS gasket when sucked down? I am looking at pistons and would like to figure this stuff out to see what I need to go. I will oring the head so not sure if you can use stock MLS gasket on it. Any info that can be shed...