Nightmare90gt
New member
- Joined
- Feb 27, 2024
- Messages
- 21
J-U-N-K
Sent from my motorola one 5G using Tapatalk
It's spalling.So your saying you wouldn’t run this cam?
It's spalling.
The tappets are concave and they are offset off the centerline of the lobe. This makes the tappet rotate as the tip of the lobe goes vertical under the tappet. The trade off is that it overloads the oil film at the shoulder of the lobe and causes them to spall out. That cam is on its way out. Mine was identical when I tore down the short block I bought.
You can reuse it as long as you are ok with what it is going to do and the labor involved to replace it. It does have a little life left in it.
Sent from my motorola one 5G using Tapatalk
I have Alldata for the dodge any suggestion on what to look up because most of the stuff is connector views not a wiring diagram. My understanding is you have to wire in the brake switch from the cummins ecm to make it work. I am going off of billet performance's 6.4 Powerstroke to 6.7 wiring he mentions it but doesn't go into too much detail.Need more info about the dodge side, but I am thinking it will be disabled without an abs input. You could get lucky. You need to know if the input to the Cummins ecm is 12 or 5v
Ford dealerships or automotive electricians are like the superheroes of the car world when it comes to decoding these things. And yeah, those wiring diagrams... they're like trying to decipher a secret code sometimes.For the Exhaust Brake Lamp signal, you're right, an LED light would be handy to show when the exhaust brake is engaged. It's a nice-to-have for sure. It might be worth reaching out to a Ford dealership or an automotive electrician for some extra guidance if you're hitting a roadblock. Sometimes, those wiring diagrams can be a bit cryptic!
What nonsense.Ford dealerships or automotive electricians are like the superheroes of the car world when it comes to decoding these things. And yeah, those wiring diagrams... they're like trying to decipher a secret code sometimes.
That’s why I have to switch from destroked to DCS mounts is for the room.Interesting. My DCS mounts have a ton of room around the starter, but I'm running the Chrysler trans adapter