Search results

I just got my Extend-a-Fender from bushwacker... had them painted to match my truck.... just got them from the paint shop and went to install. Here is my question... Are the extend-a-fenders suppose to fit just the front fender??? Mine overlap back to the cover about a half an inch of the...

Heres a pic of the crack in the dash

I have a 2000 2500 that I am parting out 100%. (most front end parts are already sold.) Short list of parts. truck has 253k 24v Engine complete - $2k mopar 47re with 48k documented from dodge miles (one year of warranty remaining) - $1200 Black and sliver bed some small rust arount wheel...

Ok so I'm working on installing an NV4500 in my buddies 2001 2wd dually... my "helper" decides to step on the clutch pedal while the slave is still dangling, not attached to the bell housing....pop the thing pops apart and blows fluid out on the floor :bang ...move forward 5 hours, not only am I...

Can anyone tell me where the system gets vacuum to control the vents?? This truck has been torn down to the frame and put back together and everything works except for the vent select. :bang Right now I've got the dash dropped, but not all the way out..there are 5 vacuum lines that attach to...

Ok this is odd...my truck has 253k on it, a rebuilt pump and factory mopar trans replace a few months back.... This is my problem, driving with no load, at speed (60-75), crest a hill or on a slight decline and the truck acts as if its starving for fuel. EGT post turbo stays around 6, trans temp...

Alright....I'm gonna let my 12v go... it out of my 95 3500 with 273k on it....runs perfect...let me know if your interested...I'm in Maryland 240-357-6752 Also have a rear out of a 2000 2500, 4 rims and tires from the same. (tires are pretty worn).

I am in dire need of a 98 12v wire harness and ecm! I've got a conversion project and this is the final piece to the puzzle (thanks:thankyou2: to Darren and Jeff Garmon!) If you've have one or know where I can get one, let me know!

I've got a little winter project going on and I've run into some issues. Without making this post to long.. I'm mating a 1995 12v with an 47RE in a 2000 bodied truck on a 95 3500 frame and chassis... everyone with me?? Long story short I had parts from two trucks and building one. Body and...