Search results

$14,000 222,000 on body White with off-road bumpers Tan leather interior Front seat is worn, but not through. I did replace the seat cushion. 22,000 on motor build Springs/retainers/pushrods Cam 15% over ddp injectors S465 2nd gen swap Trans tuned 10,000 miles on tires. Cooper sst maxx Just...

Bnib l19 Cummins 24v headstuds Went a different direction, have no need 700 free shipping

Engine from my 09 is getting rebuilt. Wondering what you all would recommend to do to it while it's torn down. Not looking for rods/pistons as I'm not going to be putting down over 600, but any cost effective things to do while it's in pieces. Trucks used for DD and towing a horse trailer right...

Ppump off a 97 auto. 340xxx miles. 600 or trade for s366 or similar

Reman unit. Low stall. Bnib, went a different route. 800 shipped lower 48. No core needed

Looking for some guidance. Trucks deleted and tuned. 191xxx miles. I bought it a month ago as is. It still had the egr in place, but unhooked. A week ago I installed delete plates as well as trans tuning. I've found a pretty impressive amount of sludge in the top end, that I've done my best to...

When I put my truck in reverse, it drops to a little under 600 rpm and steering acts funny, assumingly from the low rpms. Think it's from tuning? Trucks an 09 with unknown tuning, fully deleted

94 2500, never really had any issues starting. Replaced some cables a few months ago, and it started even better. New alternator and external regulator, even better. I drive it long distances often, never an issue. Today, I drove about 100 miles, parked for 30 or so minutes, go to start it, and...

Just installed a voltage regulator out of an 89 ram. I'm only ready 12~ volts now, both by meter, and the gauge on my dash. Is this normal, or is there an issue? Trucks a 94 12valve. Thanks

47re out of a 97 3500 4x4. Rebuilt with less than 2000miles on it, but probably needs gone through again as it's sat for a couple years with the pan off. No billet shafts, but all small parts upgraded. Looking for 450$. Located in 21001

Last night I parked my 94 2500, and when i came out, it wouldnt start. I think I have a ground issue, as when I try and turn the key, either nothing happens or lights come on dim and very very slowly light up, but not as bright as normal. Also, theres something going on with the door switch that...

hey all, I lost od in my 94 last week, but have no way to truly test the reasoning with where I am right now. I want to just hard wire a switch in, but havent been able to find detailed instructions and just want to make sure im right in my thinking. Theres a 3pin connector on the trans for od...

What are the advantages/disadvantages of running 24v tappets over 12v? Is there anything that needs to be done such as different push rods if 24v are used? Also what is a good set of push rods to use in a 700ish hp truck. Thanks

Just got my motor and all back from the machine shop. Im in the process of putting the crank back in, which was polished at the machine shop. Im using standard bearings and installing studs. Im at 160ft lbs and can not spin the crank by hand. I could barely spin it at 130ft lbs with a strap...

My motors at the machine shop right now getting cleaned up from a seeping hg. I had them do a valve job and deck the head so far. He took 20 off the head, and Im assuming he'll have to take 10 or so off the block as well. My question is in terms of clearance, I can find a 20 over gasket, but...