Search results

My 99 47re will not shift out of 1st gear without letting off the gas petal then it will shift in to second,third,O.D and lockup??? I tried a new speed sensor not sure if its the governor sensor?

looking for programmer for 99 24v tow or race really just it for better mileage and towing

99 24 valve,auto the truck idles fine but as soon as I barely touch the throttle it wants to rev to 3,000rpm! There's no control from 800rpm to 3,000rpm! I have replace injection pump,tps so not sure if the ECM is bad?

im replacing vp44 on a 99. Problem is the gear wont separate from the pump shaft. ive tryed two different pullers and bent and broke the grade8 bolts that thread in the gear and tryed heatin the gear, left the puller on there over night. still no luck! everyone ive done before pops right off...

My pump has dead pedal and jumpy throttle. Thoroughbred diesel has one for $995 blue chip has one for $1195. Has anyone ran one of these pumps?

im installing a tfod 3 manual valvebody in my 96 47re and when i was installing the rear servo spring the new spring is smaller in dia.then the stock one and in the new spring doesnt set in the retainer. has anyone had this problem? is there gonna be diffrents if i just use the stock servo springs?

I've just rebuilt my 47re and installed a trans go tfod shift kit. When cold it works fine but after it warms up when you come to a stop and take back off it's delayed engagement bringing the Rpms up to 900-1,000 it engages and shifts fine????

Trans works when cold but does not shift right and a couple mins after running it stops pulling. Pump? Or converter?

What are some good valvebody mods for 97 12v the truck is mostly stock but I want it to hold 1-2 shift longer and firm shifts

How much power can a stock output shaft handle.

Well I have owned cummins power dodges for the last ten years. I currently have a 02 3500 4x4 reg cab 24v with a 5speed and a 96 2500 reg cab 12v 2wd with twins s300 over a tmf55,full cut Dvs ,no fuel plate,ddp90hp injectors,60psi valve springs titanium retainers and keepers o-ringed head and 5"...