02 12v 6 speed 4K

cetaneaddict

Causing my own headaches
Joined
Aug 2, 2012
Messages
1,286
This truck has been put through the ringer more than once. It's a typical NY truck. Frame is clean and solid. Body is shot. Needs some tlc to be road worthy again such as front shocks, tie rod, leaf spring, tires and steering shaft clocked correctly. Needs front brakes done. I have brand new pads and a rotor sitting in the truck. Back in February I put my spare 12v motor in it since I had issues with the old 24v motor.
List of things done to it since feb:
Valair dual disk street clutch
Steering shaft
Passenger side ball joints
Front axle seals
A few u joints replaced
Moog trac bar
Motor swap, gauges work correctly
390k on the body
Reg cab long box

Motor stuff:
5x.012 injectors (feb)
60lb valve springs
HD push rods
Head studs
160hp p pump
4gsk (seth's)
23* timing
63.5/71/.8 gated
airdog lift pump
New rear crank seal
New front crank seal
4.10 gears and disk brakes in the back

It also is set up for a western unimount plow just needs the blade and controller.

Motor has about 245k on it. Was bone stock until 215k

I had full intentions to do a frame off resto but I'm buying a house in the spring and I would like too sell this or part of out if no one wants to buy it as a whole before I put more money into it.

I will post pics tonight when I get home.
Located in Warsaw,ny

$4,000 obo
 
Here's a pic I had from over the summer
 

Attachments

  • IMG_1512.jpg
    IMG_1512.jpg
    528.5 KB · Views: 0
Up dated pics
 

Attachments

  • IMG_2787.jpg
    IMG_2787.jpg
    515.2 KB · Views: 0
  • IMG_2788.jpg
    IMG_2788.jpg
    417.6 KB · Views: 0
  • IMG_2789.jpg
    IMG_2789.jpg
    573.5 KB · Views: 0
  • IMG_2790.jpg
    IMG_2790.jpg
    647.2 KB · Views: 0
  • IMG_2791.jpg
    IMG_2791.jpg
    299.8 KB · Views: 0
Back
Top