12V Billet Cam

Redline Ram

Redline Ram

.
Joined
Sep 2, 2006
Messages
362
EEP's 3.0 class billet cam low run time with cr lifters going a different route has 2 full passes on it. comes with billet retainer and has the gear tack welded on the shaft. no fuel pump lobe. $1200
 
camandlifters.jpg

camandlifters3.jpg




Cam DOES have fuel pump lobe.
 
Last edited:
Are those CR lifters? I did not think you could use those with a fuel pump Lobe IIRC? CR lifters have a 1.5 inch face.
 
i hadnt measured them but you are right. pretty sure eep said they were. must not be. they are new with the cam though. thanks for catching that!
 
Anything else you might need? I have a 12v and a 24v head? crank? rods? D80 detroit locker for 354 gears.?????????????????????
 
need fly cut pistons bushing for block to run this cam how many rpms will this cam haul pulling
 
yes you need flycut pistons i have one to send with cam so you can get your dimensions. you do not have to have bushings in the block but it is highly reccomended. cam is good for 4500+. also have the block that has bushings in it already if interested.
 
You must log in or register to reply here.
Back
Top