12v Billet Rocker Arms

[The Cummin Goat]

Still cleaning out the garage. Like the title says,
I have one set of 12v Billet Roller Rockers. They are a higher ratio than stock, 1.54 and depending on your cam will net you around .04-.05" of extra lift.

$850 OBO

 

[BluegrassDiesel]

1.54 is lower than stock.

 

[jedeka]

Who made them?

 

[The Cummin Goat]

1.54 is lower than stock.

Great catch!!!!! That is the ratio for the 24v rockers. Sorry Guys. :doh:

The Ratio for the 12v rockers is 1.815

 

[Beat68CST]

Do they have needle bearings for the rollers?
Who built em?

 

[zstroken]

Do they have needle bearings for the rollers?
Who built em?

He built them I imagine....

 

[The Cummin Goat]

They are ampco bushings.

 

[The Cummin Goat]

Someone has to want a set of Roller Rockers......

Like I said, I'm just trying to clean up some left over parts... Make me an offer, the worst that could happen is I say no!!
op:

 

[kjpcummins]

Do these just use the stock adjusters.

 

[The Cummin Goat]

Sold.

 

[9724VF350]

Anyone know this guy? Haven't seen these rockers on my doorstep yet. We messaged several times, he always responded pretty quickly. He didn't really give me the "run around" or anything, but I'm getting a bit nervous. Sent him a message yesterday, when I didn't hear back I looked and seen he hasn't been on here since 8-25.

 

[zstroken]

It took me a little while to get some stuff, but I got it eventually.
He is busy, probably doing some gloating as he whooped up on some DMAX's here recently at a local pull.

 

[pierce460]

Same here it took me awhile to get some stuff from him as well.

 

[9724VF350]

Rockers showed up today, they look great. I wouldn't hesitate to buy from Aaron again, he just seemed to have a lot on his plate.

No big deal to me, these will be used as paperweights until this winter at best.

 

[rick97dodge]

Who made them