4thesporty
New member
- Joined
- Jun 26, 2012
- Messages
- 395
I have a freshly machined 12V bare block (with main caps). Has not been touched since having it decked 10 and bored 20. It is sprayed down with WD40 and covered in my garage on an engine stand. Ready to build. It came from a '92 D250 and is and IH casting.
$600
From the same engine as above, I also have a head that has been cleaned, fresh valve job, 60lb springs installed, and oringed. Never installed since machine work was done. Also IH casting.
$600
I'll make a package deal if somebody comes and gets both. Located in Burleson, TX. Not sure on shipping, but if you can set it up, I can get them to my job (commercial with forklift, etc). I'll even crate them for a fee.
Adam
$600
From the same engine as above, I also have a head that has been cleaned, fresh valve job, 60lb springs installed, and oringed. Never installed since machine work was done. Also IH casting.
$600
I'll make a package deal if somebody comes and gets both. Located in Burleson, TX. Not sure on shipping, but if you can set it up, I can get them to my job (commercial with forklift, etc). I'll even crate them for a fee.
Adam