12V Pulling Injectors

Dodgentwo

Dodgentwo

New member
Joined
Sep 16, 2007
Messages
1,701
Hey guys,
Was wondering what injectors you guys are running for pulling? Or what are good/the best ones to use to pull with? What have you had good luck with and got the most power our of?

Thanks a ton,
Travis
 
What class and where are they running the Dragon Flows in? Also, what number of holes and hole size are they anyway? I have heard of some running HUGE injectors but don't know how much truth is behind it and I doubt many are going to want to give up there secrets...injectors are an awfull lot like Turbo's and Pumps...

RyanB
 
They are 200HP sticks and I run mine in the 2.5" Class.
Brandon
 
Most of the trucks in michigan that are in the 2.8 class are running 5x22.
 
I would say any injector shop can make them for ya, I am not sure about the dual feed passages ( they seem to make a difference )
 
What do you guys mean by dual feed? And for everyone running 5x20 or bigger what type of pumps are you guys running to need that much injector? 14mm built pumps or sigmas?
 
Good old 887 pump here 12 mm plungers and all. The dual feed is the feed tubes in the injector body.
 
How can you figure out what size your injectors are? I have injectors that JR Adkins custom made. I bought them off a guy so dont have the details. Was told JR used to run them on his Green pulling truck. They have a ring or large holes in the normal position, then a set of smaller holes toward the tip????
Anyone seen anything like this before?

Thanks, Travis
 
You must log in or register to reply here.
Back
Top