12v Storm Block Motor for sale (modified)

Texas Cowboy

Texas Cowboy

Proudly Serving
Joined
Mar 10, 2009
Messages
899
Due to promotion in my military career and not having the time to mess with my toys I would like to sale my race engine. It has been pulled out of the truck and is sitting on the shop floor. I DO NOT wish to part out the motor. This is a very well built engine and no expense was spared.

The engine has the following:
1. 5/8 CNC griddle main caps have been machined to except the griddle
2. A1 14mm studs
3. A1 Rod bolts
4. Stock pistons machined .030 off top with Swain Tech PC9 and Ceramic Gold Coat on top of pistons.
5. Helix 2 Cam
6. Titanium keepers and retainers
7. F1 60lbs valve springs
8. AGR power steering pump
9. new vac pump
10. custom cnc machined 6160 alum valve covers
11. .020 marine head gasket
12. Extrude Hone head work. Ported and polished
13. 5x.18 injectors
14. ARP 12mm studs
15. 3 angle valve job
16. Cummins complete engine overhaul kit
17. 24v marine push rods
18. 24v marine tappets
19. HTT manifold with 60mm JGS wastegate
20. S476 from bullseye power has 1.32AR
21. oil filter relocation kit
22. CDS 12mm Race Pump 600cc benched timed at 18.5*
23. International Storm engine block and head
24. Fluidampr with cam sensor relocation bracket
25. DTT custom 4.3K GSK (I have the CDS 5k springs as well)
26. Painted Cummins Red
27. turbo piping and down pipe for 5" exhaust

I even have a DTT solid cnc machince flywheel for competition only for sale as well.

I'm asking for $8500 as a start or OBO. I'm asking a lot less than I spent on parts. Please don't ask if I would part it out. Thank you for you time.

Daniel
512-844-5014 Call me anytime. I can deliver. I'm also not in a hurry to sell so don't low ball me.
 
I'm not sure to be honest. I know there is a formula to figure it out. But I would say it probably around 15:1 ish?? maybe a little lower... It does haze no matter the rmp.
 
How much was taken off the deck? .030 off the pistons plus .020 over gasket would put you a lot lower than you think at stock deck.
 
The block was straight so it was not messed with. Forgot to add the head was decked and milled just under .10 That is all the machine work that has been done to it.
 
I know with 18.5* of timing it starts like a stock motor. Get over 25* and it takes a bit.
 
Texas Cowboy said:
The block was straight so it was not messed with. Forgot to add the head was decked (measured, whatever they call it) and milled just under .10 That is all the machine work that has been done to it.
Click to expand...

This work was done by Extrude Hone.
 
Taken some phones calls yesterday and few have suggested I lower the price. I see their point on some things.

Now asking $7,000 or OBO

Thanks, Daniel
 
You must log in or register to reply here.
Back
Top