jjmachine
New member
- Joined
- May 3, 2008
- Messages
- 380
The truck is setup for Bob 2.6
It has 104,000 on the chassis but the motor was fresh last season and only has ten hooks on it.
Motor
6.7 with custom carrillo rods and ross forged pistons. The block has 14mm main studs from arp and cam bushings. It has been line bored and been bored .040 over for the ross pistons. The rotating assembly has been balanced.
The head and block were both fire ringed and decked.
List of mods
Hamilton cam and valve springs
Haisley push tubes
Arp 625 head studs
Haisley rocker studs
Ats t-4 manifold
Ed 2.6 turbo
Banks side air intake
Electric fans
250% Exergy injectors
Water to air dual core with 4inch outlets
Kennys triple disk weighted clutch
Nv4500 with upgraded input
E-locker
38 spline spool and axle from tony burkhardt
Ed butterfly kill
Driveshaft loops
Adm driveshafts
Fuel cell
2 air dog 150's
3 linked rear end
Pulling hitch
Roll pan
Racing seats
Dual cp3's with II 85% over on bottom an overdriven cp3.4 on top
Electric water pump
Stroud bell housing blanket
6 new bfg all terrains
Suspension stops
Probably forgetting things but ill add later
Pm me on here for pictures or call seven65 3sixsix 8two58 just give your email address and ill get them to you.
40000 without exergys or 43000 with exergys might be willing to deal.
It has 104,000 on the chassis but the motor was fresh last season and only has ten hooks on it.
Motor
6.7 with custom carrillo rods and ross forged pistons. The block has 14mm main studs from arp and cam bushings. It has been line bored and been bored .040 over for the ross pistons. The rotating assembly has been balanced.
The head and block were both fire ringed and decked.
List of mods
Hamilton cam and valve springs
Haisley push tubes
Arp 625 head studs
Haisley rocker studs
Ats t-4 manifold
Ed 2.6 turbo
Banks side air intake
Electric fans
250% Exergy injectors
Water to air dual core with 4inch outlets
Kennys triple disk weighted clutch
Nv4500 with upgraded input
E-locker
38 spline spool and axle from tony burkhardt
Ed butterfly kill
Driveshaft loops
Adm driveshafts
Fuel cell
2 air dog 150's
3 linked rear end
Pulling hitch
Roll pan
Racing seats
Dual cp3's with II 85% over on bottom an overdriven cp3.4 on top
Electric water pump
Stroud bell housing blanket
6 new bfg all terrains
Suspension stops
Probably forgetting things but ill add later
Pm me on here for pictures or call seven65 3sixsix 8two58 just give your email address and ill get them to you.
40000 without exergys or 43000 with exergys might be willing to deal.
