2nd gen Twin Turbo's w/ ext wastegate

GOT-Torque

GOT-Torque

is
Joined
Jul 2, 2007
Messages
5,284
Olee Poole at www.powerbypoole.com built the twins. It's a dodgezilla (HX35 w/ a 40 compressor wheel and housing) with a 14 exh housing and a tial external wastegate (38mm). The bottom turbo is a standard B2 turbo, 75mm comp, 1.32 A/R housing. I polished both compressor housings, and had all the hot parts ceramic coated as shown in the pic. Everything else was powder coated red. Made 65 psi for my setup. Layed down 600 hp 1400 ftlbs last fall on #2 with a fuel limited vp44 setup. Setup worked awesome on the street and pulling the sled.

Both turbo's have been rebuilt by Majestic turbo and have 0 miles. Selling complete setup (including AFE air filter and 5" downpipe). Exhaust manifold is not included. Pics shown below were taken just prior to my install...

Only selling to run a single for pulling class limitations...

Need to get $3300 plus shipping...

DSC07345.jpg


DSC07344.jpg


DSC07347.jpg
 
Can't think of any reason why it wouldn't work on a 3rd gen? You would need to use a 2nd gen manifold, the setup includes the pipe to the intercooler (which would be in the same location), and the downpipe is included (which starts at the primary turbo).

I think it would work...$.02
 
the intercooler pipe would need to be reworked, it is different. other than that it should work.
 
You'd also have to rework/make new intake unless you wanted to ditch a battery.
 
You must log in or register to reply here.
Back
Top