GhostRider7
New member
- Joined
- Apr 11, 2007
- Messages
- 523
I have a 3rd Gen Industrial Injection Silver Bullet 66/74/14 for sale. Turbo has approx 14,000miles and the only reason I'm selling is because I recently went to compounds. Turbo has normal side to side play, and no front to back play. I'm asking $1500 but will consider any reasonable offer.
100_2570.jpg picture by mjkarlheim - Photobucket
100_2571.jpg picture by mjkarlheim - Photobucket
100_2572.jpg picture by mjkarlheim - Photobucket
100_2573.jpg picture by mjkarlheim - Photobucket
I am also selling my Extrude Hone 45% nozzles. These nozzles ran fine when removed. The only reason I'm selling is because I upgraded to Wicked Diesels 120hp nozzles.
These nozzles started off as stock nozzles out of my 2005, so they will fit any 5.9l 04.5-07 Cummins. I shipped them to Jim Bower of Extrude Hone and he modified them to 45% over. When I had this done I was under the impression that I would get a 90hp gain from them. Since then I've looked at the Extrude Hone website and it says that 45% elargement is a 60-80hp increase. The nozzles had about 43,000miles on them when modified and now have approximately 49,000miles total on them. I dynoed 576hp with these nozzles, FASS 150, HTT 62/71/13, and an Arson III. I'm asking $400
100_2577.jpg picture by mjkarlheim - Photobucket
100_2579.jpg picture by mjkarlheim - Photobucket
Sorry for the crappy pictures, but those things are little and hard to get into focus. :bangThe rest of the nozzles looks similar to the one in the pic
100_2570.jpg picture by mjkarlheim - Photobucket
100_2571.jpg picture by mjkarlheim - Photobucket
100_2572.jpg picture by mjkarlheim - Photobucket
100_2573.jpg picture by mjkarlheim - Photobucket
I am also selling my Extrude Hone 45% nozzles. These nozzles ran fine when removed. The only reason I'm selling is because I upgraded to Wicked Diesels 120hp nozzles.
These nozzles started off as stock nozzles out of my 2005, so they will fit any 5.9l 04.5-07 Cummins. I shipped them to Jim Bower of Extrude Hone and he modified them to 45% over. When I had this done I was under the impression that I would get a 90hp gain from them. Since then I've looked at the Extrude Hone website and it says that 45% elargement is a 60-80hp increase. The nozzles had about 43,000miles on them when modified and now have approximately 49,000miles total on them. I dynoed 576hp with these nozzles, FASS 150, HTT 62/71/13, and an Arson III. I'm asking $400
100_2577.jpg picture by mjkarlheim - Photobucket
100_2579.jpg picture by mjkarlheim - Photobucket
Sorry for the crappy pictures, but those things are little and hard to get into focus. :bangThe rest of the nozzles looks similar to the one in the pic
Last edited:
