4.88 gears and rare ht 60 turbo

Tony R

Tony R

New Build is For Sale.
Joined
Dec 23, 2007
Messages
808
IM going to switch out the gears in pulling truck, going to try something diffrent.
1.dana 80 4.88 ring and pinion made by dana 7 hooks on them
2.dana 60 4.88 ring and pinion made by yukon 7 hooks also
I'd like to get 450.00 shipped obo for the set the back gear from dana cost that.
3. holset ht 60 has 2.8 bushing in it 3" charger has a very rare 20 cm wastegated exhaust housing. It was once on a navy boat that is all i know i have been running it a single. it would make a good bottom turbo in a set of twins. 500.00 shipped. obo thanks for looking Tony
 
Also interested in the specs on the charger...
 
The exducer measures about 3" and the inducer is about 3.750" on the compresor i can measure the exhaust side if you want its off and sitting on the floor ready to go also the gears are out and ready to go to a good home just let me know
 
How do you like the way the HT60 runs as a single? And do you have any pics?
 
I liked it it would start to lite at about 3800 rpms or so i thought about buying a s400 but i have another ht60 with a 27 housing on it i ran it saturday and it made a big diffrence i was 3 feet behind a guy who usually runs in the top 5 in the 3.0 prostreet class i swapped cause i had very high drive pressure i dont know if it was the turbo swap or the gear change. i can send pics just pm me a email address i dont know how to resize pics
 
You must log in or register to reply here.
Back
Top