4th Gen FloPro

WILD_PHIL

WILD_PHIL

New member
Joined
Nov 26, 2009
Messages
560
I’ve been looking around for dlete parts and have noticed that it looks like you can’t get a flopro with bungs? Is this correct. Any idea if another company offers a TBE 5” with bungs?


Sent from my iPhone using Tapatalk Pro
 
Well I liked the bungs just so there was a place to put the sensors. Seemed like a better option than zip tying them to the frame. I’ve looked at most the exhaust companies and no one offers bungs anyhow.


Sent from my iPhone using Tapatalk Pro
 
Just disconnect them at the connector and leave the sensors in the factory pipe.
 
If you end up with Flo Pro, I highly doubt you'll be disappointed. I installed a 5in TBE system on a 14 with coil spring rear and everything fit perfectly. They spent a lot of time making sure that everything fit nicely.
 
I have a stainless steel AFE 5” and I thought stuffing a 5” in there would be a pain,but it was actually pretty easy and a nice clean install.
 
You can buy dummy plugs for the wiring to keep them from getting full of crap.
 
dummins said:
You can buy dummy plugs for the wiring to keep them from getting full of crap.
Click to expand...



Wouldn’t happen to have a link for that would you? A few hours ago I was just wondering if I’d be able to find that. When these 5th gens roll out, if everything will swap I may return this truck to stock and trade it in.


Sent from my iPhone using Tapatalk Pro
 
You must log in or register to reply here.
Back
Top