5.9 shop clean out

M

Midnight Rider

New member
Joined
Nov 8, 2011
Messages
236
CR Stuff
1. Head valves are out of it intake has a crack in it comes with rockers and valve train in a box truck had 35k on it $250
2. 04.5to 07 injector cores the bodys are good the Soleniods have heat damage change them cause i used a 03 bottom end in a truck needed a good set on the ones that were going in the truck $450
3.CP3 core $250
4. 3rd gen stock manifold $100
5. AAm set of axles front and rear 3.73 gears $1200.00 for the pair

VP stuff 99 to 02
1. .040 5.9 engine block o-ringed ready for billet cam clearance for Stroker crank $1000
2. Stroked Crank 5.118 $500
3. Billet cam .318 int lift .340 ext. lift $400
4. H.d. HMR drive shafts one piece rear 1480 U-joints Front has 1410 were set up for 6spd long bed truck the rear suspension was dropped 4in to improve drive shaft angles yokes straps rear end blocks all go $1400 5 hooks on them

852 p-pump core $300

Can ship by truck buyer pays shipping cost or will meet someplace if buyer helps with fuel money pic available by text Pm me your number located around Fort Wayne IN Thanks for looking
 
Will those injector cores even be able to be sent back as cores with heat damage? Not sure what they except.
 
Not sure on the injectors I had them flowed was going to sell them as a used set but then needed the soleniods off them. The cam is from EEP there is not card with it I used a mic to figure the lift do not have the stuff to figure the duration here if its a big deal I can get it done
 
I found a fire ring std bore HMR 12v head gasket today $125 package is open but gasket and everything are there will do some tradeing on this stuff looking for 08 6.7 parts S300 turbo,super B or something streetable. Thanks for your time. 03 head with cracked intake is gone. I found a 7th CR injector core I will send with the other 6
 
Can you find out more info about the cam? I'm interested in it. How much valve relief is required? Any idea?
 
Bump
Inj. cores $400
manifold $75 still has junk turbo on it if you want it
Block $800
AAm axles $1000
908 P-Pump $250

You Pay to ship
 
Do you still have the crank?

been away for a while.........I'm interested, and if you don't do you know where I might get one?
 
Bump I am moveing need this stuff gone

AAm axles $800

Billet Cam $250

.040 Block $800

CR 24v head with titanium valves (Ferrea) 110lbs springs harden retainers and billet side entrance intake worked great used it on a VP truck comes with billet cross over tubes pistons will have to cut to use this head the valve stick .030 out of the head $1200

I will be gone to Elizabethtown KY this friday for a load of hay can bring them along if someone wants them
 
I've tried called and left messages with no response and sent you pms. I would like to get the crank, I need to start the build. If you haven't had any luck with shipping. Why don't you get me a price to ship to zip code 92111.
 
You must log in or register to reply here.
Back
Top