63mm good enough

CumminsPwr6

CumminsPwr6

New member
Joined
Jan 9, 2015
Messages
5
iv been asking around lately how my 63mm turbo would perform with the fueling mods i have, no one has been able to give me a good answer. i have a 12mm injection pump, hot street delivery valves, 5x14 injectors, 4k rev. limmiter springs, 120 pound valve springs and rack plug being supported by a airdog 150 and sump kit
:what:
 
Has your pump been benched? How many horse powers are you going for? What do you do with the truck?
 
...what's the hot-side of the turbo, what exhaust housing.

I've done 540 with my setup on a stock lift pump fed by 1/2" line from my fuel cell.
 
More pictures of your truck please. It looks kinda cool from the avatar ;-)

and 63 will be a good jump from stock regardless of the exhaust housing. I am pretty sure nothing is ever enough though.
 
If you want a horsepower number do what everyone else does and strap it to a dyno or get a timeslip.
 
CorneliusRox said:
More pictures of your truck please. It looks kinda cool from the avatar ;-)

and 63 will be a good jump from stock regardless of the exhaust housing. I am pretty sure nothing is ever enough though.
Click to expand...
The avatar is the only reason I wasn't an ass about the question
 
I was basically running the same set-up with a maxed 180 pump. Egts would get 2000* at wot, but it ran good.
 
its going to be used for towing, and no i never had the pump benched. but for hp im hoping for hi 4s low 5s
 
You must log in or register to reply here.
Back
Top