01ppump24valve
New member
- Joined
- Dec 31, 2012
- Messages
- 38
been tossing around the idea of selling my drag truck project. a lot of time and money has been invested into this truck! looking to get 20k turn key. specs are as follows.
Engine
-IH block with fire rings cut by EEP
-polished and shoot peened rods from haisley
-ARP main,head and rod bolts
-old style marine pistons that have coated skirts and have .100 fly cuts
-head has been ported and polished by EEP. intake and exhaust side
-joker fab side runner that has been flipped around to run piping on inside of truck
-chromoly push rods from R&D fuel injection
- new 5x25 scheid tripple feed IH style injectors
-13mm pump from R&D fuel injection
-keeting machine billet front cover
-stainless diesel t6 manifold
-borgwarner sxe s476/96 1.15
Trans
-fire punk full manual valve body 47RH capable of holding 1200hp
-TCS quad disk converter with a 3000 stall that was just re stalled by DPC
-billet flex plate
Chassis
-12 point cage all tig welded by Tin soldier race cars. will cert 8.50
-all intercooler piping has been made and tig welded by Tin soldier also
-custom aluminum dash
-kirkey seat
-5 point harness
-water/air set up
-2x4 back half kit from checkered racing with QA1 coil overs
-front end has djm upper and lower control arms with drop spindles
-dana 70 that has been shortened along with a 35 spline carrier and moser 35 spline axles
-custom 8 lug 16x15 real racing wheels with outer bead lock
-34.5x17 hoosier slicks
that is everything i can think of off the top of my head. Im sure theirs more i have missed
Engine
-IH block with fire rings cut by EEP
-polished and shoot peened rods from haisley
-ARP main,head and rod bolts
-old style marine pistons that have coated skirts and have .100 fly cuts
-head has been ported and polished by EEP. intake and exhaust side
-joker fab side runner that has been flipped around to run piping on inside of truck
-chromoly push rods from R&D fuel injection
- new 5x25 scheid tripple feed IH style injectors
-13mm pump from R&D fuel injection
-keeting machine billet front cover
-stainless diesel t6 manifold
-borgwarner sxe s476/96 1.15
Trans
-fire punk full manual valve body 47RH capable of holding 1200hp
-TCS quad disk converter with a 3000 stall that was just re stalled by DPC
-billet flex plate
Chassis
-12 point cage all tig welded by Tin soldier race cars. will cert 8.50
-all intercooler piping has been made and tig welded by Tin soldier also
-custom aluminum dash
-kirkey seat
-5 point harness
-water/air set up
-2x4 back half kit from checkered racing with QA1 coil overs
-front end has djm upper and lower control arms with drop spindles
-dana 70 that has been shortened along with a 35 spline carrier and moser 35 spline axles
-custom 8 lug 16x15 real racing wheels with outer bead lock
-34.5x17 hoosier slicks
that is everything i can think of off the top of my head. Im sure theirs more i have missed