98-02 Traction bars 2" DOM tube

[GOT-Torque]

I bought these a few years ago and have pulled with them quite a few times. Worked well, didn't have hoping problems or any driveline issues. They have brackets that mount on the bottom of the ubolts (under the axle) and the front brackets require you to drill two holes in the bottom of your frame rail and bolt thru it.

These aren't very long and you don't lose any ground clearance for those that mainly use their truck for work but would like to pull without breaking parts...

They don't look new anymore, but a quick sandblast and a coat of paint will fix that.

I'll try to get some pics up.

Make me an offer!

Located in SE corner of Nebraska.

 

[GOT-Torque]

EDIT - they are 1.75 DOM

pics

 

[zstroken]

What are you wanting for them? Might put these on the tow rig.

 

[GOT-Torque]

How about a trade (bars and some cash) for a T4 manifold?

I'll shoot you a PM...

 

[wpeschel]

How much cash are you wanting?

 

[GOT-Torque]

I'm thinking $300?

 

[Signal 73]

hate to take it kinda ot but do you know who made those? I have a set on my truck i bought used and everyone always asks and i dont know.

 

[zstroken]

Skyjacker used to make a set that looked like those.

 

[Babyfat]

Looks like they are on a s/b wont fit l/b

 

[GOT-Torque]

They are on a short box currently, not positive if they would fit a long box (depends on where the frame drops down I guess). You just drill two holes in the bottom of the frame rail to mount the front bracket.

Greg Long (lsfarm) on TDR built them...

 

[Signal 73]

thanks. also they are great bars for anyone looking.

 

[lbdodge24v]

are they adjustable any? or just mount right the first time around, lol. I have been looking for a set for my truck, just haven't decided what I want yet

 

[GOT-Torque]

Yes there is an inch or so of room on the heim joints to move them in/out on either end with a lock nut. I have the instructions somewhere. Lengthen them out, drill for bracket, preload them once installed. Something like that...

One end is RH and one end is LH, so you just loosen the locknuts and spin the bar...

 

[GOT-Torque]

One piece you can't see in the pictures is what the bolts go to inside the frame rail. It's a piece of steel with two nuts welded on that lays in the frame rail.

 

[dzlfarmboy]

I have a set of those I bought of C-Hawk, they work pretty nice

 

[GOT-Torque]

I've never had any issues with them at all, just taken the truck up a notch and going a bit larger on most everything... LOL