Rollin Coal
Fabricator
- Joined
- Oct 25, 2008
- Messages
- 2,232
my rear sway bar is shot, all worn out where the bushings were, and is twisted now (most likely because of it being thin) and i was thinking of trying out an addco bar.
a few potential problems i see are, the stock rear bar is 5/8" or 3/4", the addco one is 1", and comes with poly bushings, im wondering if its going to be too much in there rear w/o doing the front.
then again, most of my rear leaves are removed, and my front drop springs are like 500in/lb stiffer than the stock ones, maybe it will even it back out? now im really confused :bang:bang
anyway, the rear one is almost $200, the front is close to $250, has anyone ran them? i dont want to spend $450 unless its going to be worth it.
a few potential problems i see are, the stock rear bar is 5/8" or 3/4", the addco one is 1", and comes with poly bushings, im wondering if its going to be too much in there rear w/o doing the front.
then again, most of my rear leaves are removed, and my front drop springs are like 500in/lb stiffer than the stock ones, maybe it will even it back out? now im really confused :bang:bang
anyway, the rear one is almost $200, the front is close to $250, has anyone ran them? i dont want to spend $450 unless its going to be worth it.
