Air Dog 150, 1.0 & 1.1 a/r T-4 turbine housings and T-6 CHRA

[Mark Nixon]

Air Dog FP-150, I got it as you see it and the pump does work. Comes with inlet line, with steel draw straw, feed line from pump to filter and the filler neck splice for the return line. Wiring may or may not be complete, was removed from a 2004 prior to my acquisition, $150 SHIPPED.

1.0 A/R T-4 S-300 housing, not sure what size turbine, not cracked and not all that old from new, $125 SHIPPED.

1.1 A/R T-4 S-300 housing, same description as the one above, $125 SHIPPED.

Last I have an S-400 based CHRA with a billet compressor wheel of unknown dimensions, it has a 1.1 A/R housing with a T-6 flange, the cartridge has some MINOR radial play and the compressor wheel has some MINOR nicks, apparently from being bumped around with no compressor housing.
I'll start at $175 SHIPPED/obo on it.

Please reply here, PM or call 402-780-5127 for more information.

 

[purediesl]

Payment sent for the airdog

 

[Mark Nixon]

Thanks!
Air Dog is SOLD!

Mark.

 

[jakerc69]

pm'ed ya
and a bump for a good guy

 

[YOUNG GUNS15]

could you throw some calipers on the comp wheel of that turbo?

 

[Mark Nixon]

Minor side on the comp. is 65.5.

Mark.

 

[Mark Nixon]

I pulled the S-400 apart and a chunk broke out around the CHRA casting, so it's probably trash.
It might not leak, but I'll just sell it as-is for $100 SHIPPED.

Specs on the turbine and compressor are as follows:

Compressor minor: 65.5
Compressor major: 96.0
Turbine minor: 73.5
Turbine major: 80.0

I tried this S-400 CHRA on both of the T-4 housings listed above and it seems to clear fine on both of them.
Whether it is RIGHT or not, who knows.

Mark.