anyone run a large s400?

D

dzlpwr

New member
Joined
Nov 8, 2007
Messages
25
Just curious if any of you guys have had good luck running a 76mm S400 with the large 96mm turbine wheel on a pulling truck? Got one laying around that a guy wants to buy but Im not sure how well it will work. Hes got a ton of fuel and a very well built engine that will light up and stay on top of an S400 with the smaller 83mm turbine wheel and 1.25 housing. Also, did you guys use a T4 housing made to fit or the smaller 1.32 T6 housing?
 
I run a 76/88 on mine and drive it on the street. I run a 1.0 t3 housing on it. I would think a heavily built 12v with enough rpm could run a 96mm but dang thats a big wheel.
 
Yeah it is a pretty good size wheel but there are alot of guys running the 3.6 turbine hx60's out there with good results too.
 
If I could get a little more rpm I would say I could go even bigger on mine. I would probly atleast go to like a 1:15 t4 with my same wheel. I think I am about at the limit though at my current 3400rpms.
 
You must log in or register to reply here.
Back
Top