axle bolt circle?

R

Rods

Turbo Crasher
Joined
Apr 23, 2006
Messages
1,972
Is the measurment of the bolt circle 4.00 for the D80 dodge axle shaft?
 
Rods said:
Is the measurment of the bolt circle 4.00 for the D80 dodge axle shaft?
Click to expand...

If you are speaking of the tube to spindle... there could be some variance. If my memory is correct mine was 3.900" I came across this with my disc conversion when the caliper plates didn't fit.

I'll look back at some posts.... if I have them still and verify what the issue was.

Why are you asking?

:)
 
I found a axle list application for D80s and was seeing what will fit
 
Ha just what i was planning , is the hub a little bigger too like 5.+?
 
Yeah you have to turn down the O.D. of the axle flange...it wont fit through the wheel! Turn it down to the same size as the dodge d80 hub, witch i think is 4.75...
 
Thats what I was hoping , I could just turn it down , so did u just get a carrier from a ford like f450? thats what I'v found so far, now what length were the axles, I have DRW , I'm hoping a ford DRW is close to the same length

I found a complete rear for 250 bux but dang its in vermont :bang
 
Im tryn a detroit... i don't like them much but thats what im going with for now. Also You can get the 37 spline side gears off ebay and put them in your dodge carrier...they are all the same!

I think my axles are 36 5/8...don't remember for sure but mine is SRW. You should measure your dodge axles befor buying, cause their are some long ones that i found... like 40'' or so. and they were too long for my build!

YOU found a ford d80 for 250$...you better buy that...thats a steel!!!!! If ya didn't live so far away id buy it!!!!!
 
Last edited:
I would but its 1000 miles from me , found it on craigslist

Yea I'v seen the 37 spline axle gear set that mayb my second option

And they have the 37 axle shafts too
 
You must log in or register to reply here.
Back
Top