Bleeding clutch?

[Mudn_1]

I tried the search and didn't find much!

SB sent me their small slave to try, and I can't seem to get it to stay bled, it will build pressure fine then if i dump the pedal to push air out it loses it's pressure again?

any ideas? or proper bleeding methods?:bang

 

[DISTURBED]

They should be pre-bled and all you have to do is install them, allthe ones ive seen are that way. A couple came seperated and i had to put them together and they were also pre-bled

 

[Mudn_1]

They should be pre-bled and all you have to do is install them, allthe ones ive seen are that way. A couple came seperated and i had to put them together and they were also pre-bled

this is just the slave, i installed it with the existing Southbend master cylinder

 

[Mudn_1]

come on ya'll? I gotta drive this tomorrow

 

[K204DR]

take the slave loose, and push it in and out slowly, while someone watches the top and keeps it full of fluid. keep doing it until they dont see anymore air bubbles at the top. takes awhile sometimes.