I am having a bit of trouble on my 2014 2500 with a squishy brake pedal after the engine is shut down. I decided I would flush the old fluid and after the flush the pedal will sink to the floor when the engine is not running. Brakes work normal with the engine running.
So far I have bled the master cylinder, bled all four calipers, bled the abs unit using AlfaOBD.
Rear pads are worn but not near end of life or anything. I think one rear caliper slide pin may be seized. I have new pads and a set of slide pins ordered.
And ideas what could be causing me this trouble?
So far I have bled the master cylinder, bled all four calipers, bled the abs unit using AlfaOBD.
Rear pads are worn but not near end of life or anything. I think one rear caliper slide pin may be seized. I have new pads and a set of slide pins ordered.
And ideas what could be causing me this trouble?