Built 12v motor cheap, has knock

cumminsram

giddy
Joined
Jun 26, 2007
Messages
1,012
12 v cummins motor
Has lower end knock,

Built last winter started with bare block, no turbo, or injection pump, lift pump or lines included!

Stock bore,all new bearings and cam bushing installed

mahle style of piston,all new rings, and cut/decompressed to clear cam
Billet cam retainer,

Hamilton diesel big stick grind,billited from cast blank,radiused and bolt on retainer for gear added.

stock head casting not ported, freshned with new valve seals and a couple new valves when decked , fire ringed and set up for .20 over hg, rings and gasket from HMR.

titanium retainers and keepers and 60lb valve springs

5x.018 injectors,.093 feedports no edge filters

H11 12mm studs with 3 or so torques,these where 900ish new!
Stock pushrods, clipped waterpump,block girdle in bottom end.

1950.00 picked up, Will not seperate stuff right now want it all gone! Theres lots of money in parts here and willing to take loss because of its status. Located between Rochester and Logansport Indiana.
Also have dana 80,60 for sale and other misc parts
 
DBogo sorry I think my inbox was full has been cleaned out if you wanted to send a message.
 
i sent you a few pm's letting you know ill take it i just got to make arrangements to come get it and pay you
 
damn i really need that motor, i got the cash in hand and was all set to get it
 
Back
Top