Can someone tell me what it's worth? 3rd gen

[zwc225]

I'm looking at a 3rd gen With 153k. Can someone tell me what this is honestly worth. He's asking 24.

The cam is a 181/210 with .280/.307 lift on a 106 lsa springs are 110# on the seat enterprise engine high nickle valve seats on a 3 angle 45* back cut with gasket match porting on the exhaust ports stainless diesel exhaust manifold with a s363 over a s480 don m flux 4 injectors a cp3.3 under a cp3 with a arson 3 kit for pumps feed by a fass 150 block was bored 30 over with a deck plate connecting rods are Brazil 12v and the rotating assembly was balanced the head studs are from extreme studs .com and are equal to arp 625s fueling is done with a ts mp8 and smarty tntr also a stainless diesel coolant bypass Trans was built by mid florida performance diesel using Dtt parts and suncoast torque converter with a sonax billet input shaft and billet flex plate

 

[dangerous06]

It's worth what you want to pay for it! How many miles on the built motor? What happened to the original? If you want to see what the bank will finance look it up on KBB.com
Stock truck between 13 and 18 What yearis it?
Engine and tranny mods around 10 to 15k
So if there isn't alot of miles since the rebuild yeah it's worth it but remember you don't know what he did with it!

 

[zwc225]

Sorry should have included that. It's an 03 and the mods were done 17k ago with 153k on truck

 

[Mr. Magoo]

How clean is it, inside and underneath? Need anything?

I dont think id be paying over 20k for it

 

[Spooled]

Yeah i wouldn't be paying over 18-19k for that.

 

[John_DeereGreen]

Deckplate motor on a street truck?

I'd want to be 18-20 at most. It's 11 years old, and the mods don't add THAT much to the value.

 

[Teamfreeman04]

That is what I was thinking .... deck plate motor in a daily driver?

 

[DISTURBED]

I think it was bored and a torque plate was used not a deck plate