Control of Smarty POD by "other means."

[4x4dually]

If Edge can control the Smarty's POD, then so can any other CAN bus device.

Any tips or source code on how to do this would be much appreciated.

It'd be pretty cool to change the POD settings from my permanently mounted Murphy display. oke: I'm assuming it is nothing more than sending the ECM the % you want represented in Hex to a known location.

 

[4x4dually]

33 views and no idea. Boo.

 

[DirtyMaxx03]

Damn electrical engineers.

 

[Mudn_1]

dash daq maybe? I have no idea, just a wild guess

 

[haloman]

I bet it has something to do with how it's grounded.

 

[Scooter's Roofing]

Remember, POD works on SCI trucks too

 

[4x4dually]

Damn electrical engineers.

:hehe: Whatchu talkin' 'bout Willis?

When I get a chance I'm going to hook up the Smarty and capture all the bus traffic while changing the POD settings. I bet I can figure it out...when I get time of course. Kinda busy since I was gone all last week. I still need to mount the diplay and both cameras and build a sub enclosure and wire the amp...yada yada yada. I have a disease for thing electric. LOL And still need mouting options for my strobes. :evil

 

[TravisG]

I bet it has something to do with how it's grounded.

He would so ban you if he could right now.

 

[4x4dually]

He would so ban you if he could right now.

One of these years I'm going to kiss the right ass and have that kinda of Power On Demand.

 

[haloman]

You just need to find some common ground with the right mod.

 

[4x4dually]

You just need to find some common ground with the right mod.

I pretty much consider most of them brothers at this point. Feeling must not be mutual. :hehe:

 

[TravisG]

I pretty much consider most of them brothers at this point. Feeling must not be mutual. :hehe:

Not true. We just don't want you to ban Daniel.

 

[4x4dually]

Not true. We just don't want you to ban Daniel.

I wouldn't do that.

At least not for some silly "ground" joke. LOL

 

[4x4dually]

I have a few "sniffs" of the Smarty POD commands......I think I need a terminating resistor....getting an CAN error.

Anyone new reading this and know what bytes to send the ECM to modify POD??????

Jesus...someone has to know......I sure would like to not have to "figure it out" for once. Com'mon...someone hook me up.