Cummins NV4500 bellhousing and fork

Mark Nixon

Mark Nixon

No Savior among the flesh
Joined
Feb 26, 2009
Messages
8,678
I have some NV4500 bell housings and forks sitting around.
$300 SHIPPED.

PM, Reply or call 402-780-5127.
 
I am interested in one of the bell housings and forks you have.
Also interested in a nv4500 trans for a 2000 dodge 2500 4x4 if you happen to have one at a decent price right now maybe we could work something out for both.
I am in the process of collecting my parts to swap my auto to a manual.
I can be reached here.. or e-mail at robert.i.kelley@gmail.com
or
707-349-6116
Thanks
~Robert
 
Last edited:
I still have 2 bell/fork combos available.
I do not have ANY NV4500 transmissions whatsoever, at this point.

Mark.
 
My buddy Ty might be shooting you a call


Sent from my flashscan v2
 
Okay, I have some other NV4500/NV5600 related stuff to off, so here's a list:

NV4500 bell with fork, $300 SHIPPED.

Manual/Auto 1994-2002 block plate, $125 SHIPPED.

2001 Dark gray console set-up in very nice condition, includes 4wd, upper and lower boots, also includes the rear floor bracket and even comes with the cup pads, $140 SHIPPED.
I also have other 98+ consoles in worse condition and some odds and ends for them.

Dark Gray (also have light gray) dash pocket for 1998-2002 5 or 6 speed, $25.

2WD NV5600 tranmission, has the large 1-3/8" input, has less than 10k on a rebuild, comes with shifter assembly, handle and clutch fork, $2000/obo.

NV5600 screw-on (same as 98+ NV4500 Dodge) shift handle, has shift knob with 6 speed indicator, or I can swap it to a 5 speed indicator, $50 SHIPPED.

1994-1997 Dodge NV4500 shift lever, the 'L' bent one, $40 SHIPPED.

Shifter stub for "bottle top" 1994-1997 NV4500, $40 SHIPPED

Shifter stub for a 1st Gen with an NV4500, uses a screw-on handle like a straight handled Getrag shifter does, really, really hard to find, $45 SHIPPED.

Shifter boots and trim ring for a 1st gen with an NV4500, also very hard to find, $75 SHIPPED.

1 pair of NEW pedal pads for 1st gen, $30 SHIPPED.

2 pairs of nice USED pedal pads for 1st gen, $20 SHIPPED.

PM, REPLY or call 402-780-5127.
 
I just want to make sure it isn't corroded and I will take it
Can you take PayPal
Just let me know
 
It's not corroded at all, in fact it's a greasy pig!
I can do the PayPal thing.

PM me and I'll give you the address.

Mark.
 
Still have a bell and fork available, as well as all of the list above.^^^

Mark.
 
Just picked up the following:

Early (1994-1997) 2nd gen clutch/brake pedals, includes bushings, pedal support pin and the pushrod retention clips, $100 SHIPPED.

Late (1998-2002) 2nd gen clutch/brake pedals, includes bushings, pedal support pin, push rod retaier clips AND the bolt-in hydro master bracket, $115 SHIPPED.

See my list above for more manual trans goodies! :D

Mark.
 
I now have an NV4500 4wd CORE transmission removed from a 1996 2500, as well as a 5 speed NP241DLD and the rest of an NV4500 conversion.
The conversion includes:

Pedals.
OEM Hydros.
Flywheel.
Block Plate.
Bellhousing.
Transmission (needs rebuilt).
Transmission shifter, w/upper & lower boots.
NP241DLD 29 spline transfer case.
5 speed transfer case shifter.

I'd take $1200 for all of it.

Reply, PM or call 402-780-5127, if interested.
 
I pulled top cover off the transmission above to inspect the damage.
I found that it needs an input, cluster (counter shaft) and I'd throw a bearing kit and blockers (synchro rings) at it while it was down.
The very front tip of the main shaft did survive fine, as did the case, top cover and all other gears.

Mark.
 
You ever get a chance to dig out that dash pocket to see if it's in good shape?
 
I have it in good shape.
Dug it out back after you asked, then got busy and forgot it. :doh:

Mark.
 
You must log in or register to reply here.
Back
Top