Dana 60 front parts

[TrailTamer]

I did the Ford knuckle-out conversion with 35 spline shafts so I have lot of parts left over to unload.

I have the following off my 97 Dodge Ram 2500 front D60

-knuckles (no ball joints) $100
-2 unit bearings, with rotors, both still good $100
-5 axle shafts (2 stub shafts, CAD 2 piece long inner, short inner) with newer spicer SPL55-3X, still tight and good $100 for all
-CAD collar and actuator assembly, both still good and worked fine $makeoffer
-calipers and pads (still good) $makeoffer
-dust plate (the thing that 'cover' the rotor) $makeoffer
-30 spline D60 side and pinion gears and cross pin. $makeoffer

All Dodge D60 parts for $250, OBO

Ford ball joint Dana 60 from 95-97 F-350

-housing with 3.55 gears and open carrier still in it, looks good $250
-stock 35 spline inner axle shafts $120
-stock 30 spline stub shafts $50

Or get the Ford d60 with those parts for $350, OBO

All are "or best offer"

Trades can be considered

Located in Rochester, NY 14623

I can put new ball joints in the knuckles before send it you at only parts' cost.

I prefer not to ship the ford D60 housing. I will try to ship most stuff through USPS's flat rate box. Axle shafts likely will be shipped via ups or FedEx or by your preference.

(Knuckles are gone, only housing and gears/carrier/yoke remaining)

 

[not enoughsmoke]

pm sent