lenahan05
Comp Diesel Sponsor
- Joined
- Jan 31, 2009
- Messages
- 1,173
I have 2 trucks for sale.
1.)
2002 Shortbed 2wd Single Cab. White
-Built 12V engine.
(208/220) cam
Fully built head with aftermarket intake (oringed)
Studded top and bottom
All new cummins gaskets from top to bottom
Built 12mm pump
peened hardened and balanced rotating assembly
steed t4 with gate
currently billet 63/68/.83 gated
5x16s
stainless 093 lines
every part on the engine is new and has been powdercoated.
-Built Trans
Brand new from HTS.
Precision 2200stall triple disc converter
billet input and intermediate (stock output)
4 trans cooler stacked with 2 fans on each and stainless braided lines from front to rear.
($6800 for converter an trans)
-Chassis
The truck was built with the intention on street and drag racing.
Has custom tubular upper and lower controls arms with double adj strange coilovers. Rear is also setup with strange coilovers with 3 leaf setup. It has been lowered substantially and the frame has been notched and boxed.
Also has brand new wheels and tires. 18" Fuel and Nittos I believe.
The truck itself has no rust at all.
-Needs
Intercooler needs hooked up to the compressor outlet.
Needs new lift pump and wired in (current airdog 200 had filters ripped out during loading because the truck is so low.
Needs the injection pump and trans linkage hooked up.
Needs headlights installed. I have brand new ones.
Needs front and rear bumper.
I'm sure theres something Im forgetting.
$10,500 OBO
This truck also has a custom ford 9'' housing with a new 4 link setup, chromoly backhalf and strange brake setup for rear with brand new Billet Specialities Lightwieght series wheels on 33'' hoosiers if you interested in finishing my project. All it needs is the axle shafts and r&p.
$2500 firm
10 point chromoly cage for this truck $700 firm
Truck #2
1996 2wd 2500 ram shortbedded. It raced this truck last summer and ran a best of 7.30 98mph 1/8. Its flat black and is in pieces. Truck is solid no rust but it is not glamorous. It is not a roller at the moment. Front upper and lower controls arms are off but all bushings and ball joints have been replaced. Ready to install.
No Engine
No Fuel Pump
Intercooler with HD Boots
Sport Bumper with hood stack
Dual trans fans with 4 coolers an stainless braided lines in rear.
20 gal fuel cell
2 race bucket seats with 4 point harness
b&m ratchet shifter
boost/drive/pyro/fuelpress/trans gauges in dash.
interior is gutted for racing.
custom driveshaft and loops
fresh trans. billet input, custom VB, Phil Taylor 4 Disc Converter.
$7000 obo.
As for other parts, I have tons of other stuff I just need out of my way.
10+ 12v Balanced/Polished Cranks-$180 piece
10-15 sets of 12v rods in good shape - $85 set
2-5 12v heads. Some stock and 2 fully built and ported. Stock $250.
Built heads call for info.
A few blocks that needs some type of work done to them - $100 piece.
2 billet tappet covers - $180 each
Set of coated std. 286110 pistons with lightened pins and balanced rods with total seal rings - $750.
Couple Alternators - $65 each
Turbos
New s480 FMW 80/87/.90t4 - $1700
s475 Billet 7 blade comp 83/74 turbine .9 and 1.1 T4 housings w/ 360 thrust - $1200
s591 - $1600
Fresh std bore 12v block 14mm studs with new bearings & custom lightened racing crankshaft - $2000 Firm
I prefer to have one person come and pick all of this stuff up at once and I will make someone the deal of a lifetime. I want it all gone. These trucks and parts would be very profitable to someone who has the time to finish them and/or turn the for a good profit or for someone keep and race/daily drive them for fun like I did. I just don't have any desire or the time for the diesel stuff anymoe and my plans have changed. Don't bother PMing me or texting me. CALL ONLY. I work 7 days a week and don't have time for questions from people who have no money. Don't waste my time yankin my chain if your not serious. I will be more than happy to answer any questions and send pictures to people who are serious. I would be interested in trades on race trucks and parts for a nice daily driver. No junk. $20,000 and up ONLY.
(812)698-1736
1.)
2002 Shortbed 2wd Single Cab. White
-Built 12V engine.
(208/220) cam
Fully built head with aftermarket intake (oringed)
Studded top and bottom
All new cummins gaskets from top to bottom
Built 12mm pump
peened hardened and balanced rotating assembly
steed t4 with gate
currently billet 63/68/.83 gated
5x16s
stainless 093 lines
every part on the engine is new and has been powdercoated.
-Built Trans
Brand new from HTS.
Precision 2200stall triple disc converter
billet input and intermediate (stock output)
4 trans cooler stacked with 2 fans on each and stainless braided lines from front to rear.
($6800 for converter an trans)
-Chassis
The truck was built with the intention on street and drag racing.
Has custom tubular upper and lower controls arms with double adj strange coilovers. Rear is also setup with strange coilovers with 3 leaf setup. It has been lowered substantially and the frame has been notched and boxed.
Also has brand new wheels and tires. 18" Fuel and Nittos I believe.
The truck itself has no rust at all.
-Needs
Intercooler needs hooked up to the compressor outlet.
Needs new lift pump and wired in (current airdog 200 had filters ripped out during loading because the truck is so low.
Needs the injection pump and trans linkage hooked up.
Needs headlights installed. I have brand new ones.
Needs front and rear bumper.
I'm sure theres something Im forgetting.
$10,500 OBO
This truck also has a custom ford 9'' housing with a new 4 link setup, chromoly backhalf and strange brake setup for rear with brand new Billet Specialities Lightwieght series wheels on 33'' hoosiers if you interested in finishing my project. All it needs is the axle shafts and r&p.
$2500 firm
10 point chromoly cage for this truck $700 firm
Truck #2
1996 2wd 2500 ram shortbedded. It raced this truck last summer and ran a best of 7.30 98mph 1/8. Its flat black and is in pieces. Truck is solid no rust but it is not glamorous. It is not a roller at the moment. Front upper and lower controls arms are off but all bushings and ball joints have been replaced. Ready to install.
No Engine
No Fuel Pump
Intercooler with HD Boots
Sport Bumper with hood stack
Dual trans fans with 4 coolers an stainless braided lines in rear.
20 gal fuel cell
2 race bucket seats with 4 point harness
b&m ratchet shifter
boost/drive/pyro/fuelpress/trans gauges in dash.
interior is gutted for racing.
custom driveshaft and loops
fresh trans. billet input, custom VB, Phil Taylor 4 Disc Converter.
$7000 obo.
As for other parts, I have tons of other stuff I just need out of my way.
10+ 12v Balanced/Polished Cranks-$180 piece
10-15 sets of 12v rods in good shape - $85 set
2-5 12v heads. Some stock and 2 fully built and ported. Stock $250.
Built heads call for info.
A few blocks that needs some type of work done to them - $100 piece.
2 billet tappet covers - $180 each
Set of coated std. 286110 pistons with lightened pins and balanced rods with total seal rings - $750.
Couple Alternators - $65 each
Turbos
New s480 FMW 80/87/.90t4 - $1700
s475 Billet 7 blade comp 83/74 turbine .9 and 1.1 T4 housings w/ 360 thrust - $1200
s591 - $1600
Fresh std bore 12v block 14mm studs with new bearings & custom lightened racing crankshaft - $2000 Firm
I prefer to have one person come and pick all of this stuff up at once and I will make someone the deal of a lifetime. I want it all gone. These trucks and parts would be very profitable to someone who has the time to finish them and/or turn the for a good profit or for someone keep and race/daily drive them for fun like I did. I just don't have any desire or the time for the diesel stuff anymoe and my plans have changed. Don't bother PMing me or texting me. CALL ONLY. I work 7 days a week and don't have time for questions from people who have no money. Don't waste my time yankin my chain if your not serious. I will be more than happy to answer any questions and send pictures to people who are serious. I would be interested in trades on race trucks and parts for a nice daily driver. No junk. $20,000 and up ONLY.
(812)698-1736
Last edited:
