E.D. 66mm turbo w/billet wheel

[Deputydog]

I purchased this turbo from Chris @ Engineered Diesel in July and it has about 2500 miles on it since installing it.

It is on my Fummins which has an early 2004 CR, but this will work for an 03-07 CR.

Turbo is a T4 non-wastegated turbo with the T3-T4 adapter so it will work on a T3 manifold (or T4). It has a billet wheel and spools very quick. Specs are 66/74 with a polished compressor housing.

I did 771 HP with this turbo in October :thumbsup:

I am selling it because I just bought twin turbo's from Chris @ E.D. and they are going to be installed next week.

Asking $1375 shipped!

 

[ctdiesel99]

Bump for a good price!

 

[Macktruckdriver]

Wish it was t-3 id buy it.

 

[Deputydog]

Wish it was t-3 id buy it.

I have the adapter that I will include.. :Cheer:

 

[burtonboarder]

Man greg if this was a 2nd gen itd be sold...

Sent from my DROIDX using Tapatalk

 

[12valvePwr96]

It'd work fine on a second gen...

 

[brianjbeach85]

2nd gen is T4, so this will work on a 2nd gen? how much boost has been pushed on this guy?

 

[Wbsdiesel]

2nd gen is T4, so this will work on a 2nd gen? how much boost has been pushed on this guy?

2nd gen stock is T3. Sure it could be used on a 2nd gen, might have to mess around with the intercooler pipe though.

 

[Macktruckdriver]

Can't run t-4 foot in 2.6 class here

 

[Deputydog]

2nd gen is T4, so this will work on a 2nd gen? how much boost has been pushed on this guy?

I've seen about 55 psi thru it. Before I put this turbo on, I had a BD Killer B (63mm) this 66 spools as good if not a bit better.

 

[Deputydog]

Sold